Cílem práce bylo analyzovat vliv teploty a nízkomolekulárního barviva disperzní červené 1 (DR1) na spektroskopické vlastnosti tenkých vrstev připravených z polymetylmetakrylátu (PMMA) a kopolymeru polymetylmetakrylátu-co-akrylátu disperzní červené 1 (PMMA-co-DR1). Důraz byl kladen zejména na stanovení teploty skleného přechodu (Tg) vrstev spektroskopickými metodami. DR1 byla studována jako aditivum v tenké vrstvě, i jako kovalentně vázaná součást PMMA. Na analýzu vzorků byla použita UV-VIS a infračervená (IR) spektroskopie. Další vhodnou metodou pro toto studium je fluorimetrie, která je v práci diskutována teoreticky. Z naměřených IR spekter a jejich závislosti na teplotě byla stanovena Tg tenkých vrstev a byl vyhodnocen vliv tloušťky tenké vrstvy na Tg. Bylo zjištěno, že Tg tenkých vrstev je nižší než pro standardní formu PMMA a PMMA-co-DR1 (např. dle stanovení Tg z granulí či prášku) a se snižující se tloušťkou tenké vrstvy mírně vzrůstá.
Anotace v angličtině
The thesis the evaluates effect of temperature and an addition of low-molecular dye Disperze Red 1 (DR1) on the spectroscopic properties of thin films prepared from Poly(methyl methacrylate) (PMMA) and copolymer Poly[(methylmethacrylate)-co-(Disperze Red 1 acrylate)] (PMMA-co-DR1). The work was focused on the determination of glass transition temperature (Tg) of the prepared thin films with spectroscopic methods. DR1 was analysed as additive for thin films, as well as covalently bonded component of PMMA. UV-VIS and infrared (IR) spectroscopy were used to analyse the samples. Another method suitable for this type of analysis is fluorimetry discussed in theoretical part. Tg of thin films was determined from the measured resolved IR spectra temperature and the effect of thin film thickness on Tg was evaluated. The results revealed that Tg of thin films is lower than Tg determined for bulk material PMMA and PMMA-co-DR1 (Tg determination from pellets or powder) and that Tg of thin film slightly increases with decreasing the film thickness.
Cílem práce bylo analyzovat vliv teploty a nízkomolekulárního barviva disperzní červené 1 (DR1) na spektroskopické vlastnosti tenkých vrstev připravených z polymetylmetakrylátu (PMMA) a kopolymeru polymetylmetakrylátu-co-akrylátu disperzní červené 1 (PMMA-co-DR1). Důraz byl kladen zejména na stanovení teploty skleného přechodu (Tg) vrstev spektroskopickými metodami. DR1 byla studována jako aditivum v tenké vrstvě, i jako kovalentně vázaná součást PMMA. Na analýzu vzorků byla použita UV-VIS a infračervená (IR) spektroskopie. Další vhodnou metodou pro toto studium je fluorimetrie, která je v práci diskutována teoreticky. Z naměřených IR spekter a jejich závislosti na teplotě byla stanovena Tg tenkých vrstev a byl vyhodnocen vliv tloušťky tenké vrstvy na Tg. Bylo zjištěno, že Tg tenkých vrstev je nižší než pro standardní formu PMMA a PMMA-co-DR1 (např. dle stanovení Tg z granulí či prášku) a se snižující se tloušťkou tenké vrstvy mírně vzrůstá.
Anotace v angličtině
The thesis the evaluates effect of temperature and an addition of low-molecular dye Disperze Red 1 (DR1) on the spectroscopic properties of thin films prepared from Poly(methyl methacrylate) (PMMA) and copolymer Poly[(methylmethacrylate)-co-(Disperze Red 1 acrylate)] (PMMA-co-DR1). The work was focused on the determination of glass transition temperature (Tg) of the prepared thin films with spectroscopic methods. DR1 was analysed as additive for thin films, as well as covalently bonded component of PMMA. UV-VIS and infrared (IR) spectroscopy were used to analyse the samples. Another method suitable for this type of analysis is fluorimetry discussed in theoretical part. Tg of thin films was determined from the measured resolved IR spectra temperature and the effect of thin film thickness on Tg was evaluated. The results revealed that Tg of thin films is lower than Tg determined for bulk material PMMA and PMMA-co-DR1 (Tg determination from pellets or powder) and that Tg of thin film slightly increases with decreasing the film thickness.
3. Příprava vzorků tenkých filmů a jejich analýza.
4. Vyhodnocení naměřených dat.
5. Zpracování infračervených spekter a extrakce informace o Tg polymeru.
Seznam doporučené literatury
Pavia DL, Lampman GM, Kriz GS et al. Introduction to Spectroscopy. USA:Brooks/Cole. 2009,2001. ISBN-13: 978-0-495-11478-9.
Böhm S. Strukturní analýza organických sloučenin. Praha:VŠCHT, 1995. ISBN 807-0-80235-9
Urbánek P, Kuřitka I, Daniš S et al. Polymer. 2014. 55, 4050-4056.
Soyoung K, Roth CB, Torkelson JM. Journal of Polymer Science: Part B: Polymer Physics. 2008. 46, 2754-2764.
Grohens Y, Brogly M, Labbe C et al. Polymer. 1997, 38, 5913-5929.
Zhang Y, Zhang J, Lu Y et al. Macromolecules. 2004. 37, 2532-2537.
Terasaki M, Khasnah, Ozaki Y et al. Polymer. 2018. 135, 69-75.
Seznam doporučené literatury
Pavia DL, Lampman GM, Kriz GS et al. Introduction to Spectroscopy. USA:Brooks/Cole. 2009,2001. ISBN-13: 978-0-495-11478-9.
Böhm S. Strukturní analýza organických sloučenin. Praha:VŠCHT, 1995. ISBN 807-0-80235-9
Urbánek P, Kuřitka I, Daniš S et al. Polymer. 2014. 55, 4050-4056.
Soyoung K, Roth CB, Torkelson JM. Journal of Polymer Science: Part B: Polymer Physics. 2008. 46, 2754-2764.
Grohens Y, Brogly M, Labbe C et al. Polymer. 1997, 38, 5913-5929.
Zhang Y, Zhang J, Lu Y et al. Macromolecules. 2004. 37, 2532-2537.
Terasaki M, Khasnah, Ozaki Y et al. Polymer. 2018. 135, 69-75.
Přílohy volně vložené
2 tabulky
Přílohy vázané v práci
tabulky
Převzato z knihovny
Ne
Plný text práce
Přílohy
Posudek(y) oponenta
Hodnocení vedoucího
Záznam průběhu obhajoby
Studentka představila komisi výsledky své diplomové práce. Poté byla komise seznámena s posudky a hodnocením vedoucího a oponenta (hodnocení vedoucího: A, hodnocení oponenta: A). Studentka pak zcela zodpověděla dotazy oponenta, a následně byly ostatními členy komise položeny následující otázky:
doc. Ing. Tomáš Sedláček, Ph.D.: Nalezená závsilost zvyšování Tg se snižující se tloušťkou vrstvy byla nějak ovlivněna použitým substrátem?
Student/ka otázku zodpověděl/a zcela.
prof. Ing. Roman Čermák, Ph.D.: Rozšířila jste možnost vlivu substrátu na imobilizaci polymerních řetězců?